Make sure that there is a sufficient number of supports to distribute the weight properly without excessive point loads, and the capacity and dimensions of the trailer are sufficient to carry the boat and its engine, equipment, battery, boating accessories and fuel on board. Pay special attention to exposed areas and edges of hull, such as strakes and steps in the hull, during loading, deloading and transportation.
A boat trailer that does not have sufficient capacity or that is poorly maintained can become damaged and cause a danger on the road.
-
Make sure that the trailer capacity is sufficient to also carry the weight of the engine, fuel and equipment.
The hull of the boat can be damaged if there is an insufficient amount of supports on the trailer or during the storage.
The trailer must be a little nose heavy. Make sure that the boat is securely fastened to the trailer, that it cannot move into any direction, and that the side supports provide an even support for the weight of the boat.
Before loading the boat on the trailer:
-
Remove any unnecessary weight from the boat.
-
Drain the bilge water.
-
Adjust the side supports of the trailer so that the most weight rests on the keel supports, and the side supports only offer lateral support.
-
Protect the boat by placing suitable padding between the tie down straps and the boat, if necessary.
-
See the engine manual for any instructions on trailering.
-
Make sure that the doors and hatches are properly closed.
-
Pay attention to any equipment and accessories in the boat during trailering.
-
Make sure you secure all loose items in the boat.
-
Do not use a hood, canopy, tonneau cover or other similar top or cover on the boat during trailering.
These hoods and covers can become detached at high speeds and damage the boat and cause a danger to traffic.
A hood or other cover flapping in the wind during trailering can damage the boat surface.
-
Keep the hood in its dedicated storage compartment during trailering, or remove the hood completely, if necessary.
-